Create a scope
Define which targets a probe assesses, from which vantage point, on which ports, in which mode (black, gray or white box) and in which time window.
On this page
A scope is a named scan: which addresses to check, with which probe, how and when. You can have several, for example one for the DMZ from the internet and another for the office network from inside.
Before you start
Administer permission on Vulnerabilities.
A probe available for the vantage point you want: a Install a local probe, the Use the Argunis probe and verify external targets or a Create a private connection.
For the perimeter, the external targets registered and verified.
For gray or white box, the Store credentials for gray and white box in the vault.
Steps
Go to Security (SIEM) → Vulnerabilities → Scopes and click New scope.
Enter a Name (for example,
dmz-oficina).Choose the Vantage point and the probe:
Vantage point | From where | Which probe |
|---|---|---|
Local | From a probe installed in your network | A local probe |
Private connection (tunnel) | The Argunis probe comes in through a tunnel, only during the window | A private connection |
Perimeter (external) | From the internet, the way an attacker would see it | A local probe or the Argunis probe |
In What to scan, fill in:
Targets: IPs, CIDR networks or names, one per line. Over a private connection, only IPs or CIDRs within the tunnel's networks.
Exclusions (optional): what must not be touched, for example the router.
Ports: Top 100, Top 1000 or All (1-65535).
Scan type: Connect (no privileges) or SYN (requires privileges).
Maximum rate (packets/s) (optional): empty uses 150 from the perimeter and 300 for local or tunnel.
In Schedule, define when it runs. See Scan and schedule scans.
In Mode, choose:
Black box: no credentials, sees the same as an attacker from outside.
Gray box: with service credentials; check at least one.
White box: with server credentials; check at least one.
Read the Scan authorization and check I have read and accept the scan authorization on behalf of the company.
Click Create scope.
Start with black box and Top 1000 to see your exposure, then create a white box scope for critical servers: it's the one that fills the Hardening view.
What happens next
The scope appears in the list with its mode, vantage point, probe, targets and its Accepted authorization. A scope with Authorization pending can't be scanned until an administrator clicks Accept authorization.
To delete a scope, click the trash button on its row.