IP addresses
See by subnet which IPs are free, in use, monitored, reserved or not seen, detect conflicts and reserve IPs with a reason.
On this page
Network → IP addresses gathers what ARGUNIS already knows about your network to tell you, by subnet, which IPs are used, by whom and since when. It installs nothing new: it uses what the monitoring probes see (discovery and network devices' ARP tables), the inventory and the agents.
ARGUNIS only reports: it does not assign IPs or write to your DHCP, DNS or hosts.
Where the subnets come from
The subnets read by your network devices' topology.
Those from discovery jobs.
The ones you add manually.
The /24 of IPs that are seen and do not match any of the above.
View a subnet
Go to Network → IP addresses.
In Subnets, each card shows the subnet, its name or where it came from, the VLAN, how many IPs are taken out of those available, the free ones, the usage percentage and the conflicts.
Click a subnet. Its IP grid opens, colored by status. Click a status in the legend to show or hide it (Free ones start hidden).
Click an IP to see its details: MAC, vendor, name, inventory host, what saw it and when. From there you can Reserve this IP.
Below the grid, the table lists each IP with Status, MAC · vendor, Name, Host, Seen by and Last seen.
Status | What it means |
|---|---|
Monitored | The IP belongs to a host you monitor in ARGUNIS |
Reserved | You marked it as reserved, with a reason |
In use | It was seen in discovery or in an ARP table in the last 30 days |
Not seen | It was seen at some point, but not in the last 30 days |
Free | No one has seen it and it is not reserved |
When a subnet goes over 90% usage, its percentage is marked in red and the page shows a warning with the IPs that remain free. It is only an on-screen warning: it does not open an incident.
Conflicts
If the same IP appears with two different MACs in the last 7 days, the IP is marked in red and its details say which ones they are. It is usually a duplicated static IP or a host that changed its network card.
Add a subnet manually
Click Add subnet.
Enter the Subnet (IPv4 between /16 and /30, for example
192.168.10.0/24) and, if you want, the Name, the VLAN and a Note.Confirm.
To remove it, open it and click Remove subnet. Only manually added subnets can be removed; their IPs and reservations stay.
Reserve an IP or a range
Click Reserve IP (or Reserve this IP in an IP's details).
Enter the IP (or start of range), the End of range if it is a range, and the Reason, for example "Lab firewall".
Confirm.
The subnet's reservations appear in Reservations. With Remove, the IP is counted again based on what is seen.