Add a host from a monitoring probe
Configure in detail how a probe checks a host on your network, with no agent: protocol, logs, extra checks, and receiving syslog and traps.
The monitoring probe checks the host from your network, without installing anything on it: metrics, logs and checks, with the credentials from the vault. Use this screen to add a host with all the options or to change how the probe checks it.
Before you start
You need permission to operate in Infrastructure.
There must be at least one active monitoring probe. If there isn't, the screen tells you with a link to Monitoring probes. See Install a monitoring probe.
The credential must be in Settings → Monitoring → Credentials.
Steps
Open the screen in one of these ways:
For a new host: go to the category in Infrastructure and click Add from a probe.
For an existing host: on its page click Configure and then the Monitor from the probe link, or the Change button in the Monitoring from the probe panel.
If it's a new host, complete the Host section: Name, IP or domain, Category and Group (optional).
In Probe and protocol:
Choose the Monitoring probe.
Choose the Protocol: SSH (Linux), SNMP v1/v2c/v3 (firewalls, switches, routers, UPS…), WinRM (Windows) or Ping only (availability).
Enter the Port if it isn't the usual one.
Choose the Credential (vault). It travels sealed to the probe.
Choose the Metrics interval (or Ping interval).
Complete the protocol options:
WinRM: HTTPS (5986), Don't verify the TLS certificate, Authentication (NTLM only with HTTPS, or Basic) and Services to watch (one per line).
SNMP: select Interfaces (status, traffic, errors and discards) and Storage (disks and memory), and add Extra OIDs (one per line, up to 20).
SNMP with the Network module in your plan: select Collect topology (LLDP/CDP, MAC, ARP, routes) and choose its interval. It comes selected on switches, routers, firewalls and access points, and builds the map in Network → Topology.
In Logs to fetch (SSH and WinRM), select Fetch main logs and choose what to read:
SSH: journald with its priority and units, and Files (one per line).
WinRM: the Event Log channels System, Security and Application.
In Specific logs (SSH only), click Add specific log and enter the Path, the text or expression to Search, the Level (Error, Warning or Info) and the interval. Each match is recorded as an event with that level.
In Extra checks, add what the probe should check against the host: Ping, TCP port or HTTP/HTTPS (with URL, method, expected codes and text that must be returned).
In Received from this host, select Receive syslog or Receive SNMP traps if the host sends them to the probe's IP. The screen shows you what the chosen probe receives and warns you if its reception is turned off.
Click Add host (new host) or Save.
The logs the probe fetches from the host reach the SIEM just like the agent's logs.
What happens next
The probe receives the instructions within seconds.
On the host page, the Monitoring tab shows the Monitoring from the probe panel with each instruction, its last result and, depending on the protocol, the interfaces, the top-consuming processes, the Windows services, the extra OIDs, the HTTP checks, and what was received via syslog and traps.
Stop monitoring from the probe
On the same screen, click Stop monitoring from the probe. The host goes back to being checked from the ARGUNIS cloud over SSH or SNMP. A WinRM or ping-only host doesn't have this option, because it can only be monitored from a probe.
If the probe that monitored a host is revoked or deleted, the page shows No probe: assign another one. Click Choose another probe and save.