DocumentaciónHelp

Review a probe's page

What a monitoring probe's page shows, how to schedule its automatic update and how to add a test check.

On this page

A probe's page shows its status, its server, its syslog and trap reception, and all the instructions it is running.

How to get there

  1. Go to Settings → Monitoring → Monitoring probes.

  2. Click the probe's name.

What it shows

  • Status: connection, last heartbeat, version, key date, who registered it and when, and whether it is revoked.

  • Host: its own server (with a link to its page), host name, Site (you can change it right there), system, architecture, how many instructions it has and how many hosts it monitors.

  • Probe update: how it is updated (see below).

  • Syslog and trap reception: see Receive syslog and traps on the probe.

  • Instructions: each check the probe runs, with its name, host, type, target, interval, last result and output.

The probe's own server does not use the plan's server quota; the hosts it monitors do count as devices.

Schedule the automatic update

  1. In Probe update, select Update the probe automatically when a new version is available.

  2. Set the window with From, To and the Time zone (for example America/Santiago).

  3. Click Save.

The probe only updates within that window. If a version fails, it is not retried on its own: the page shows the error and waits for you to retry it or for another version to come out.

Enable, disable or delete an instruction

In the Instructions table, click Disable or Enable in the row, or the trash icon to delete it.

Add a test check

A test check is a ping or a TCP connection to a host on the probe's network, to validate that the probe reaches it. If you are an administrator:

  1. In Instructions, click New test check.

  2. Choose the Type: Ping (the host responds) or TCP (a port accepts connections).

  3. Choose the Interval and enter the Host (name or IP) and, for TCP, the Port.

  4. Optional: a Name. Leave Enabled selected.

  5. Click Add.

The result is updated at each interval in the Instructions table.

To monitor a host permanently, add it in Infrastructure with Check from set to the probe. See Add a host from a monitoring probe.

Related

Search Argunis Monitoring

Type at least 2 characters to search Argunis Monitoring.

↑↓ to navigate · Enter to open · Esc to close