DocumentaciónHelp

Enable topology collection on network devices

Turn topology reading on or off in bulk for your switches, routers and firewalls monitored over SNMP from a probe.

On this page

Network → Network devices lists the devices a probe monitors over SNMP. From here you enable topology collection, which uses the same SNMP credential and only reads: LLDP/CDP, address table, ARP and routes.

Before you start

  • Your plan must include the Network module.

  • You need the administrator role and permission to operate on Servers.

  • The devices must be monitored over SNMP from a probe. If there are none, on the page of each switch, router or firewall use Monitor from the probe with SNMP. See Add a host from a monitoring probe.

Steps

  1. Go to Network → Network devices.

  2. In the SNMP devices from the probe table, review each device with its Probe, whether Collection is on and how often, the Last result and the Last collection.

  3. Select the checkbox of the devices you want to change (or Select all).

  4. In the action bar, choose the interval in Every.

  5. Click Enable collection, or Disable to turn it off.

The Result for each device appears below. Close it with Close.

You can also enable topology device by device with the Collect topology (LLDP/CDP, MAC, ARP, routes) checkbox in Monitor from the probe. It comes selected for switches, routers, firewalls and access points.

Related

Search Argunis Monitoring

Type at least 2 characters to search Argunis Monitoring.

↑↓ to navigate · Enter to open · Esc to close