DocumentaciónHelp

View the topology

See the devices in each subnet with what your probes and the inventory already see, and the link map of your network devices over SNMP.

On this page

Network → Topology has two maps:

  • Devices by subnet: the devices ARGUNIS already sees in each subnet (probe discovery, ARP tables, inventory, and agents), without needing SNMP.

  • The links map: how your network devices are connected, based on what the probes read over SNMP (LLDP/CDP, address tables, ARP, routes, and OSPF and BGP neighbors).

Devices by subnet

  1. Go to Network → Topology. At the top is Devices by subnet, showing the subnet with the most devices.

  2. Switch subnets with the list on the right.

  3. The subnet is in the center; its gateway hangs from it, if known, and each device hangs from the gateway. The color is its status:

Color

What it means

Green

Monitored or in use

Amber

Not seen for 30 days

Gray

Reserved

Red

The IP appears with two different MACs

  1. Click a device: if it's monitored, its page opens; if not, its IP opens in IP addresses.

Up to 58 devices per subnet are shown; the rest are in IP addresses.

Link map

Before you begin

Steps

  1. Go to Network → Topology.

  2. Review the indicators at the top:

    • Collecting devices: opens Network devices.

    • Trunks and Edges: links between network devices and toward end hosts.

    • Links down.

    • Discovered, not monitored: what the network sees that isn't in Infrastructure. Opens Discovered.

    • OSPF adjacencies and BGP sessions, if there are any.

  3. Choose the graph View: Whole network, By site, By subnet, By VLAN, or By host. Except for Whole network, then choose which one.

  4. In the By host view, choose how many hops to show around the host.

  5. Select Show end hosts if you also want to see what hangs off the edge ports.

  6. In Layers, turn Layer 2 (LLDP/CDP/MAC), OSPF, and BGP on or off.

How to read the map

  • Color of each device: Operational, With alerts, With problems, or No data.

  • Red dashed line: link down. Amber: link with errors.

  • The arrow points to the side closest to the probe ("connected to").

  • OSPF is drawn with a dashed line and BGP with a dotted line.

On large networks, the map shows the network devices first and tells you how many it left out. Choose a site, subnet, VLAN, or host to see the rest.

Links list

Below the map, the Links table shows each link with its Status, both ends and their ports, the Type, the VLAN, the Speed, the Errors, and who saw it (Seen by). Click a link to open its page.

Link page

A link's page shows:

  • Link: status and since when, type, VLAN, speed, where it was learned from, errors and discards in the interval, first and last time seen, direction, and how many MACs are on the port. For OSPF and BGP, also the area, AS, IP, and Router-ID on each side.

  • End A and End B: port, alias, status, speed, MAC, input and output errors, discards, and PVID.

  • Open incidents on the link.

With Simulate outage you see what would happen if the link goes down: incidents, probable cause, and notifications. It doesn't create anything.

Rebuild the map

If you are an administrator, Rebuild redoes the correlation with the latest data from the devices. Above the map you see the date of the last correlation.

Related

Search Argunis Monitoring

Type at least 2 characters to search Argunis Monitoring.

↑↓ to navigate · Enter to open · Esc to close