DocumentaciónHelp

Review and adjust a probe

Review a probe's status, which hosts it monitors and what it runs, turn on syslog and trap reception, and create test checks.

On this page

The probe's page shows everything it does and lets you confirm that it reaches your network.

Steps

  1. Go to Settings → Monitoring → Monitoring probes and click the probe's name.

  2. Review:

    • Status: connection, last heartbeat, version, and the dates of the key and the registration.

    • Host: its own server, the site and the details of the host it runs on.

    • Hosts it monitors.

    • Instructions: each check it runs, with its host, type, target, interval, last result and output.

Receive syslog and traps

  1. In Syslog and trap reception, select what you want to receive (for example, Syslog UDP, Syslog TCP, Syslog TLS or SNMP traps (UDP)) and the port for each one.

  2. Click Save reception.

The probe installation must publish the same ports; otherwise, what the hosts send doesn't arrive. In addition, each host's configuration states whether its syslog or traps are received.

Create a test check

A test check confirms that the probe reaches a host on its network, with a ping or a TCP connection.

  1. In Instructions, click New test check.

  2. Fill in the type, the target and the interval, and save.

  3. Review the result in the table at the next interval.

To pause it, click Disable; to delete it, click the trash can icon.

Each host's instructions are changed on the host's page, not here.

Related

Search Argunis Monitoring

Type at least 2 characters to search Argunis Monitoring.

↑↓ to navigate · Enter to open · Esc to close