Discover hosts on your network
Create an inventory job so a monitoring probe discovers the devices in a range of your network, without scanning ports.
On this page
An inventory job asks a monitoring probe to discover the devices in one or more ranges of your network: IP, MAC, vendor, type and name. The probe does not scan ports (the vulnerability probe does that).
Before you start
Your plan must include the Network module.
You need the administrator role.
There must be a monitoring probe registered in Settings → Monitoring → Monitoring probes, installed on the network you want to discover.
Optional: a read-only SNMP credential in the vault, to better identify each host.
Steps
Go to Network → Discovered.
In View, choose Inventory jobs.
Click New job.
Fill in the form:
Name, for example Head office LAN.
Probe that runs the inventory.
Ranges: one per line. Each one can be an IP, a CIDR from /24 to /32 or a span within the same /24. Up to 256 addresses per job.
Exclusions: IPs or spans that are never touched, for example sensitive hosts.
Speed: Low (up to 20 packets/s) or Normal (up to 100 packets/s).
Frequency: Manual only, Every 6 hours, Every 12 hours, Every day, Every week or Every 30 days.
Maximum duration (minutes): from 10 to 720.
In SNMP identification, optionally choose the SNMP credential (optional). With it, the probe identifies the vendor, model and type of each host that responds. Select Collect network device topology (LLDP, CDP, OSPF, BGP) if you want their topology to enter Network when you monitor them.
Optional: turn on Only within a time window and set From, To, Days and Time zone. If "to" is earlier than "from", the window crosses midnight. When the window closes, the inventory stops.
If it is a sensitive network, turn on Sensitive network (notifies if a new host appears) and select Notified to and authorized by cybersecurity. This is mandatory because the inventory can trigger alarms in other systems (IDS/IPS/EDR), and who authorized it is recorded.
Leave Enabled selected and click Save.
Run and follow a job
In the jobs table you see the ranges, the speed, when it runs, the next run and the last one (In progress, Completed, Partial, Failed or Stopped). In each row you can:
Run now (play icon).
Stop, if it is in progress.
Edit or Delete.
What the probe uses to discover
ICMP echo, ARP, reverse DNS, mDNS and NetBIOS, without exceeding the packets-per-second cap you chose. With the optional SNMP credential it also identifies the host model and its topology.
What happens next
The hosts found appear in the Hosts view of Discovered. They do not enter Infrastructure, the Network map or the plan quota until you monitor them. See Monitor a discovered host.