DocumentaciónHelp

Live network

See the internet, your firewalls and routers with their real traffic and, under each one, the networks it routes with their hosts; filter by site or subnet and put it on the NOC screen.

On this page

Network → Live network brings the Network module together in a single scene that refreshes every 15 seconds.

What it shows

  • Internet: the uplink interface of each firewall or router (the one with the most inbound traffic).

  • Firewalls and routers from Infrastructure, with up to two interfaces and their real traffic (inbound blue, outbound white).

  • Under each one, its networks: the subnets from IP addresses it routes (it is their gateway or has an IP on them). Each box shows the network, its VLAN, how many hosts it has and its usage, and lists the first hosts with their status: green monitored, light blue in use, amber not seen in 30 days. If that network's interface is known, its traffic runs along the line.

  • Related in the CMDB (dotted box): servers that have a "connected to" or "depends on" relationship with the device on their page.

  • Bottom: the networks not routed by any firewall or router in the inventory, and the other network devices (switches, access points).

Click a network to open it in IP addresses, a host to open its page (or its IP, if it is not in the inventory) and a firewall or router to open its page.

Filter

At the top, choose a Site or a Subnet. With a subnet you see only that network and the device that routes it.

How to set it up

To see

Where

A firewall, router or switch

Infrastructure, with its category

Its traffic

In its Configure, "Monitored from" the probe over SNMP (or the "Network interfaces" plugin)

Its networks

Network → IP addresses: networks come automatically from discovery and ARP; add one manually with its gateway so it hangs from the right device

Each network's interface and traffic, and more hosts

Collect topology in its Configure or in Network → Network devices

The device card warns about what it is missing ("Ping only" or "Collect topology") and opens its Configure. The scene's How it works button repeats this table.

NOC screen

Click NOC screen to see it alone in full screen, or add Live network to the rotation in the NOC screen's Configure. It is also a Dashboard block ("Live network").

Related

Search Argunis Monitoring

Type at least 2 characters to search Argunis Monitoring.

↑↓ to navigate · Enter to open · Esc to close